Skip to content
Free ground shipping for all orders over $100!

10% off site wide through 4-30 use code | EXPO_10
Free ground shipping for all orders over $100!

10% off site wide through 4-30 use code | EXPO_10

QuickTech ™️©️®️: Calibration Station ft Mahlkonig E80 Supreme!

All aboard! This is a Black Rabbit QuickTech ™️©️®️ train headed to calibration station.

Tools: - Flat Head Screwdriver

Steps:

· Close hopper & grind off any remaining beans.

· Turn off your grinder and remove the hopper.

· Unscrew the two collar screws without removing and slide collar to the unlock position.

· Press and hold the locking crank to remove the adjustment ring.

· Spin the burrs counter clockwise while adjusting the dial until you feel the burrs touch.

· Adjust the dial back 1/8th to a full step.

· Place the adjustment ring to the finest position.

· Use the notch on the grinder to properly align the adjustment ring to zero.

· Place the collar back, lock, and tighten the screws.

· Finally, put the hopper back on, flip that switch, and you're back in business for another successful day.

Thank you for choosing to board Black Rabbit QuickTech ™️©️®️ Tech Tip Train.

Previous article QuickTech ™️©️®️: @Mahlkonig Guatemala Stepped Grinder Calibration!
Next article QuickTech ™️©️®️: Clean that Flapper. ft the Mahlkonig E65 GbW!